Light Is Something You Borrow: Siting Video in Rooms That Were Never Cinemas
Photo: Henrysz, CC BY-SA 4.0, via Wikimedia Commons
There's a moment, about four hours before the doors open, when you realise the room has quietly vetoed your plan. The blackout isn't blackout. The wall is bowed. The only socket is behind a piano nobody can move. And the caretaker has just mentioned, cheerfully, that the heating clicks on at six and sounds like a tram.
This isn't a failure of preparation. It's the normal condition of showing video in Britain's real rooms — the ones with parquet, hymn boards, fire doors and a smell of floor polish. So instead of treating that as a problem to be solved, treat it as the material you're working with.
Light is a material, not an obstacle
Start by visiting the room at the hour your event actually happens. A hall that reads as gloomy at 10am can be full of bounced daylight at 6pm, and a side chapel that's dark all winter becomes a greenhouse in June. Take a phone photo of the wall at that hour, then take another with the lights off. That second photo tells you more than any spec sheet.
Only then do you think about brightness. A small projector throwing a big image across a church hall will lose to a single unshaded window; the fix is rarely more lumens, it's a longer throw or a smaller image. If you can't control the light, design for it: a piece that reads at 60% contrast on a pale limestone wall will still read when the sun comes round. High-contrast line work survives. Subtle mid-greys do not.
For blackout, the honest answer is blackout lining on a hired rail, or a roll of heavy lining paper taped edge to edge with the wall behind it — not bin bags, which flap, rustle and read as a student flat. Never tape to lime plaster or to anything painted before about 1960; you'll take the surface with you and the church will remember.
Where the projector goes, and how not to trip over it
Projector placement is where most small shows come unstuck. A few rules that have saved us repeatedly:
- Forget keystone. Correcting a bad angle digitally costs you resolution and adds a soft edge that looks like a mistake. Move the machine. It's almost always possible.
- Get the throw ratio before you commit. A short-throw lens in a stairwell will blow the image up the wall behind your audience's heads. A long throw down a corridor can be lovely.
- Keep the beam out of eyelines. If people have to duck, they will stop looking.
- Cable runs go along walls, not across floors. Where they must cross, use a proper cable ramp or heavy rubber matting, and gaffer nothing to a heritage floor.
If you can't get the projector high enough, project lower and accept that people will walk through the image. In a stairwell that's the point — passing through is the choreography. Design a three-minute loop with no beginning and no ending, and let people catch fragments on the way up and different fragments on the way down.
Sound spill is the thing nobody budgets for
A stairwell has the acoustic personality of a drum. A church hall has a reverb tail that will smear a spoken-word track into porridge. Two options work: go directional (a single small speaker aimed at a listening position, at low volume), or go intimate (headphones, a listening bench, a handset on a hook).
The third option — one loud Bluetooth speaker on a windowsill — is how you get a noise complaint from the平 neighbour and a piece that sounds like a phone in a lift. Don't.
Also ask, in writing, what else is happening in the building. A toddler group at 3pm under a room you're using at 7pm is fine; a choir rehearsal next door is not.
Walls, power and the caretaker
Some practicalities that tend to get decided in a panic on the day:
- Wall prep. Test the surface with a torch at a raking angle before you trust it. Bowed plaster, dado rails, radiators and hymn boards all leave shadows — sometimes beautifully. If the surface is dark, matt and slightly textured, your contrast will be better than you expect.
- Fixings. Ask what you're allowed to use, get it confirmed by whoever holds the building, and assume the answer to screws is no. Tension wire between existing hooks, freestanding frames and weighted bases cover most situations.
- Power. Find every socket on your recce, photograph them, and note which circuit the kitchen is on. Bring your own extension leads, RCD adaptors and tested cables, and know who turns the power off at the end of the night — because it might be before you've finished.
- Heat and noise. Projectors hate being boxed in. Keep airflow clear and don't balance one on a chair.
Let the room be in the piece
A stairwell, a side chapel and a community centre all give you something a black box never will: a context that does half the work. The sound of a door, the draught under a fire exit, the way people stand rather than sit because there's nowhere to sit — these are compositional materials.
So write them into your plan. Note the sightlines and design for partial viewing. Time your loop to the length of a natural pause. Put the caption card somewhere people queue.
And document it. Photograph the installation at the same time of day as the event, with people in it if you can, because the next venue will ask what the work looks like in a room and you'll want the evidence.